Standing seam and metal panel roofing, roof repair and full replacement in Allenton. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
A coating buys real years on the right roof and wastes money on the wrong one. We will tell you honestly which kind you are looking at.
A metal roof is the one that outlives the mortgage. We install exposed fastener panels and standing seam over solid decking and real underlayment, with around twenty standard colors to choose from.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Not every hailstorm ruins a roof. We look before we tell you anything, and if the damage is only cosmetic we will say that too.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Here is what working with us looks like in Allenton: you call, somebody comes out and measures, and you get a written estimate with the panel or the shingle spelled out on it. If you say go, we schedule you and we show up on that day.
The crew tarps the beds, keeps the yard picked up as they go, and runs a magnet over the drive before pulling out. Small things, but they are the ones Allenton homeowners still mention a year later.
Why people around Allenton call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
Straight answers to what Allenton homeowners ask us most often.
A typical Allenton shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Much less than people expect. Over solid decking with underlayment under it, a Allenton metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
For most Allenton homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Any dry stretch works. We roof in Allenton year round, though we schedule shingle work for when it is warm enough for the strips to seal properly, and we watch the forecast so your house is never left open overnight.
Most Allenton metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Often, yes. Plenty of the Allenton roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Real feedback from homeowners whose roofs we have worked on.
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"They roofed our addition and tied in the porch that runs off it. One crew, one number to call, and every line of it matched up."
Roofing Brothers also serves these towns near Allenton.